We now have a newly designed throttle cable bracket for Edelbrock carburetors. It is designed for use with Ford vehicles whose throttle cable end has a 9/16" square mounting hole that the cable sheath snaps into. 

It mounts on the rear carb studs and has a 5 1/4 inch bolt center which most Ford manifolds have. 

This bracket moves the cable mounting point 1 1/2 inches farther to the left to accommodate Edelbrock's basic carburetor design as compared to Ford's stock carburetors.

The bracket also has provision for clearance of the vacuum port connection on the base of the Edelbrock carb.

This bracket was successfully trial fit on a customer's 70 Mustang 351C with an Edelbrock 1406 carb.

This bracket is zinc phosphate coated and is a high quality bracket made out of 14 ga steel. 

Made in AMERICA by an American Craftsman and VETERAN.